REMOVING AND INSTALLING
TRAILING ARM

Important!
Rear wheel alignment must be checked
after installation - see Gr. 32.

Remove side panel - see Gr. 41.
Remove wheel - see Gr. 36.
Unscrew brake disc, parking brake cable
and ABS signal sender - see Gr. 34.
Remove output shaft - see "Removing
Wheel Bearings" in 33 41.


32 00 000
41 35 000
36 10 000
34 11 000

Punch mark position of eccentric washer
to control arm.
Unscrew nut.

Installation:
Use washer (1).
Replace nut.
Tightening torque = 110 Nm with car loaded
down to normal position (see Specifications
for Group 32).


See Specifications

Unscrew bolt.

Installation:
Use washer (1).
Tightening torque = 100 Nm with car loaded
down to normal position (see Specificatons
for Group 32).


See Specifications

Unscrew bolt.

Installation:
Tightening torque = 110 Nm.

Unscrew and remove bolt (1).
Take off adjusting sleeve (2).

Installation:
Tightening torque = 77 Nm with car loaded
down to normal position (see Specifications
for Group 32).


See Specifications

Rubber Mount Assembly:

1 Trailing arm
2 Rubber mount
3 Rubber cap
4 Threaded sleeve

E Pressin-in direction

A 59.5 mm