REMOVING AND INSTALLING
WHEEL

Pull off wheel cap with wheel cap
puller (car tools).

Important!
Wheel is balanced electronically.
Proceed as follows to avoid remounting
mistakes and imbalance.

- Loosen wheel bolts.
- Position wheel that valve is at bottom;
reinstall in same position.
- If more than one wheel is removed
at same time, mark location of
wheels on the tires (e.g. with chalk).
- Mark position of wheel to wheel hub
(to avoid remounting mistakes).
- Mark position of wheel lock to wheel
(to avoid imbalance).
- Unscrew wheel bolts.

Installation:
Tighten wheel bolts crosswise.
Tightening torque = 100 ± 10 Nm.
Recheck tightening torque after 1,000 km,
if new wheel rims are installed for
first time.

Installation:
Clean wheel center centering collar and
bearing surfaces of wheel rim and coat
with Plastilube (available from HWB).
Check wheel bolt threads and taper for
wear, replacing wheel bolts if necessary.
Lubricate wheel bolts threads lightly,
but tapers must not be lubricated for
installation.