REPLACING RUBBER MOUNTS FOR CONTROL ARM Important! Always replace rubber mounts on left and right sides and use rubber mounts of same make (recognized on mounts). Remove control arm holder - see 31 12. Press rubber mount out of holder with Special Tool 31 2 130. 31 12 000 | |
Installation: Check installed position! Arrow on rubber mount faces cast boss (1) on holder. Clean holder and rubber mount to remove grease. Rubber mount is marked with dots of "light blue" paint (2). | |
Press rubber mount into the holder flush from the bevelled side with Special Tools 31 2 130. | |
Checking Rubber Mounts: Load down car to normal position - See Gr. 32. Measure gap (A) with a feeler gage blade. Specification: A = 0.7 ... 1.7 mm (0.027 ... 0.067"): Replace rubber mounts, if the measured value deviates from the specified value. 32 00 000 |