REMOVING AND INSTALLING HOLDER FOR CONTROL ARM Punch mark center of control arm. | |
Unscrew holder for control arm. Installation: S = washer Tightening torque= 42 Nm for 8.8 bolts 47 Nm for 9.8 bolts | |
Pull holder off of control arm with Special Tools 31 2 151 and 00 7 500. Important! A rubber mount pulled off of the control arm must never be reused. Pulling off dry destroys the rubberized interior sleeve. Replace rubber mount - see 31 12. Always replace rubber mounts on left and right sides and use rubber mounts of the same make (recognized on the mounts). 31 12 000 | |
Coat control arm journals with an approved lubricant*. Apply Special Tool 31 2 153 in the control arm bore. Pull holder/mount on control arm against the stop with Special Tools 31 2 152/154 and 00 7 501. * Source of Supply: HWB | |
Note: Centering bores (large diameter) of holder face the axle carrier. | |
Important! Bolt holder on body immediately. Tightening torque = 42 Nm for 8.8 bolts or 47 Nm for 9.8 bolts. Load down car to normal position - see page 32 - 0. Leave car in normal positiion at least 30 minutes and avoid bottoming the suspension. The bubricant will be evaporated after about 30 minutes and the control arm will fit tight and correctly positioned in the rubber mount. Non-conformance with these procedures could lead to serious impairment of vehicle handling! |