Lift out retainer (2) of accelerator shaft. | |
Disconnect spring (3) of accelerator shaft. Slide bearing sleeves (4 and 5) to the side. Lift out accelerator shaft. | |
Transfer stop light switch (1). Note: Removing the stop light switch (1) requires pressing out the plunger and sleeve. Compress retainsers and pull out switch. | |
Installation: Insert switch that protruding part is in opening in holder. | |
Transfer lever for steering column (12), clutch pedal (4) with spacer (5) and over-center helper spring (6), brake pedal (7) with spacer (8) and spring (9). | |
Installation: Check installed position of spring (9). | |
Transfer spacer (10) and bearing sleeves (11). Check bearing sleeves, replacing if necessary. General Information: All sliding surfaces must be coated lightly with a lubricating grease. Approved lubricants - see 35-00. 35 00 000 |