REMOVING AND INSTALLING
UPPER CONTROL ARM AND
REPLACING RUBBER MOUNT

Important!
Rear wheel alignment must be checked
after installation - see Gr. 32.

Remove coil spring - see 33 53.


Siehe auch 32 00 000
Siehe auch 33 53 000
 
Unscrew bolt.

Installation:
Tightening torque = 110 Nm.

133054 - click to zoom
 
Unscrew bolt.

Installation:
Tightening torque = 110 Nm with car loaded
down to normal position (see Specifications
for Gr. 32).


Siehe auch See Specifications
133058 - click to zoom
 
Support final drive with a transmission
lifter*.
Disconnect plug.


Siehe auch * Source of Supply: BMW Parts
133011 - click to zoom
 
Unscrew left and right stabilizer mounts.
Unscrew stabilizer on control arm.

133010 - click to zoom
 
Unscrew nut (1).
Lower transmission lifter.
Pull bolt out of control arm and take off
control arm.

Installation:
Use stop washers (2) at top and bottom.
Tightening torque = 180 Nm.

133012 - click to zoom
 
Press out rubber mount with Special Tools
33 3 351 and 33 3 352.

3633102 - click to zoom
 
Press in new rubber mount (1) flush with
Special Tools 33 3 351 and 33 3 352.

3633103 - click to zoom