REPLACING RADIAL OIL
SEAL FOR OUTPUT FLANGE

Remove final drive - see Gr. 33.
Remove propeller shaft - see Gr. 26.
Lift out lockplate (1).

Installation:
Replace lockplate.


Siehe auch 33 00 000
Siehe auch 26 11 000
3223019 - click to zoom
 
Apply Special Tool 23 1 200.
Hold output flange with Special Tool
23 0 020.
Unscrew collar nut with Special Tool
23 1 210.

Installation:
Install collar nut with a bolt cement*.
Tightening torque:
Initial torque = 170 Nm (123 ft. lbs.).
Loosen colar nut.
Final torque = 120 Nm (87 ft. lbs.).


Siehe auch * Source of Supply: HWB
3223020 - click to zoom
 
Pull off output flange by hand or, if too
difficult, pull off output flange with
Special Tool 33 1 150.

3223021 - click to zoom
 
Pull out radial oil seal with Special
Tool 00 5 010.

3223022 - click to zoom
 
Drive in radial oil seal flush with
Special Tool 23 1 370.
Check oil level, correcting if necessary.

3223023 - click to zoom