EXCHANGING TRANSMISSION Remove transmission - see 23 00. Transmission Identification: BMW code* pasted on front case section. 23 00 000 * See Parts Catalog | |
Transfer spring (1) and release lever (2) with release bearing (3). Note: Coat transmission shaft in area of splines and guidepins lightly with Microlube GL 261**. ** Source of Supply: HWB | |
Installation: Pack lubricating groove (N) with Molykote Longterm 2. Coat guides (F) and bearings (L) lightly with Molykote Longterm 2. Non-conformance could cause bearing to seize on the guide sleeve. | |
Transfer shift rod joint. Push back locking sleeve (1). Drive out cylindrical pin (2). | |
Transfer exhaust carrier (3). Tightening torque = 22 Nm (16 ft. lbs.). Important! Transmission are supplied filled with oil. Consequently it is only necessary to check the oil level after installation of a transmission. | |
Transfer reverse gear switch (4) and electric lead holder (5). |