REMOVING AND INSTALLING DOOR WINDOW Caution! Pull out fuses 25 and 26 between the various steps in the interest of safety (danger of being clamped in door or window) - see 51 00 for general information. 51 00 000 | |
Installation: Check for correct seating of window in seal after installation with the convertible top closed and the door raised, adjusting the window if necessary - see 51 33. Raise the door. Loosen screw (1). Unscrew screws (2). Lower the door. Take off door trim panel (upper). 51 33 000 | |
Unscrew screws and pull out expansion rivets. Take off plate. | |
Pull out expansion rivet. | |
Raise the door lower the window. Unscrew screw (1) and pull out expansion rivet (2). Lower the door and take off the edge guard. Raise the door. Unclip and lift out door trim panel from above. | |
Unscrew screws (1) and take off window plate. Unscrew screws (2) and take off window stops. Installation: Lower the door window. Insert window stops and screw on nut. Raise the window, press window stops against the windwo glass without force and tighten. Lower the window. Install the window plate. | |
Raise the window to an opening of about 150 mm (6"). Pull out fuses 25 and 26. Pull out retainer from the sid. | |
Hold the window glass tight and disconnect the window lifting arm. Installation: Insert the retainer in the slide and then connect the window lifting arm. | |
Lift window glass. Press the door push button and push the door down. Lift out the door window glass from above. | |
Note: Make sure that the spring is not lost. Picture was taken with the roller guide removed. | |
Installation: Window holders are cemented with Sikaflex X-255. |