BMW Z1»41 - Body»41 34 000 - Tail panel - remove and install
REMOVING AND INSTALLING TAIL PANEL
Unscrew bolts.
Installation: 1 Bolt 2 Outer body panel 3 Rubber grommet - don´t displace while tightening bolt (1) 4 Chassis
Pull off clip (1) from the wheel house and clips (2) from the tail light opening.
Installation: The flat side of clip (2) faces down.
1 Side panel 2 Clip 3 Rubber seal 4 Front or tail panel
Pull plugs out of expansion rivets with a nippers or side cutter. Pull out expansion rivets from above. Pull back rubber mounts out of the tail panel.
Installation: Coat rubber mount (2) with a rubber lubricant. Install tail panel by sliding guides (1) into rubber mounts (2). Check for correct seating of seals (3) to mating parts.
Installation: Check for correct seating of bottom retainers. Press on tail panel until retainers engage.