REMOVING AND INSTALLING
FRONT PANEL

Unlock engine hood.
Unscrew bottom panel screws.

Unscrew front screws of wheel house
cover.

Pull up wheel house cover and pull off
clips.

Installation:
The flat side of clip (2) faces down.

1 Side panel
2 Clip
3 Rubber seal
4 Front or tail panel

Unscrew lenses of left and right turn
signals. Take off rubber seals. Pull off
center rubber seal (cemented).

Installation:
Replace center rubber seal (self-
adhesive).
Left/right rubber seals are held by the
turn signal lenses.
Check for correct seating of rubber
seals between headlights and turn
signals.

Unscrew screws.
Knock out plugs in clips toward the
inside.
Lift out clips from above.

Lift off front panel forward.

Installation:
Slide guides into rubber mounts on
left and right sides.
Check for correct seating of wheel
house trim panels.