REMOVING AND INSTALLING
REAR BRAKE PADS

Remove rear wheels - see Gr. 36.
Pry off plastic caps.
Unplug pad wear indicator on the right
side.

Note:
Only use same type of pads on one
axle.


Siehe auch 36 10 000
134020 - click to zoom
 
Unscrew guide bolts (2).

Installation:
Only clean guide bolts - do not lubricate
them with grease.
Inspect threads.
Replace guide bolts which are not in
perfect condition.
Tightening torque = 31 to 35 Nm
(23 to 25 ft. lbs.).

134022 - click to zoom
 
Press out clamp (3).
Pull off floating caliper toward rear.

134024 - click to zoom
 
Take off outer brake pad.
Inner brake pad is located in piston
with a spring.

Important!
Always replace all brake pads of both
calipers on one axle.

Coat back of brake pads lightly with
Plastilube* on the brake piston contact
surface.


Siehe auch *Source of Supply: HWB
3234059 - click to zoom
 
Installation:
Push back piston completely.
Clean brake pad guides and recesses
with a brush*.

Important!
Extract pad dust - never blow it out.
Check dust cover for damage.
Lubricate guides lightly with Plastilube*.


Siehe auch * Source of Supply: HWB
3234060 - click to zoom