BMW Z1
»
32 - Steering and Wheel Alignment
»
32 13 000 - Power steering gear - remove and install
REMOVING AND INSTALLING
POWER STEERING GEAR
Note:
Check toe after installation.
Draw hydraulic fluid out of tank - do not
reuse it.
Unscrew nuts on left and right sides
and press tie rods off of track arm with
Special Tool 32 0 070.
Installation:
Clean journals and bores to remove
grease.
Replace self-locking nuts.
Tightening torque = 36.5 ± 3.5 Nm.
Unscrew pressure pipe.
Plug open connections with dust caps.
Installation:
Replace seals.
Tightening torque
M 14 = 35 Nm
M 16 = 40 Nm
Unscrew bolt.
Push up steering spindle.
Installation:
Bolt must be located in groove of the
steering shaft.
Replace self-locking nut.
Tightening torque = 19 Nm.
Unscrew steering gear on front axle
carrier.
Installation:
Tightening torque = 43 ± 4 Nm.