REMOVING AND INSTALLING COIL SPRING FOR SPRING STRUT Remove spring strut mount - see 31 33. Take off upper spring retainer with ring and coil spring. Important! Only install pairs of springs with the same BMW number (1) (located on end of spring) and same color code (2) (either with or without stripe of red paint) on one axle. Refer to the Parts microfiche for a survey of springs to vehicle type and, if applicable, special equipment (e.g. air conditioner, sport suspension, etc.) as well as introduction dates. Part numbers can be determined with help of the BMW number on the spring and therefore springs can be found for a vehicle type in accordance with the Parts microfiche. Examples: 1. Spring with red color code add 1 to number on spring 1 125 332 = part number 1 125 333 2. Spring without red color code add 2 to number on spring 1 125 332 = part number 1 125 334 31 33 000 | |
Installation: Use an upper spring ring with thickness (A) = 9 mm (0.354") for springs with a red color code. | |
Installation: Check protective tube and rubber damper, replacing if necessary. | |
Installation: Check upper and lower rubber rings, replacing if necessary. Ends of coil spring must bear on shoulders in the lower and upper spring retainers. |