REPLACING CONSTANT
VELOCITY JOINT FOR
PROPELLER SHAFT

Remove propeller shaft - see 26 11.
Remove hose clamp.


Siehe auch 26 11 000
2826102 - click to zoom
 
Lift out circlip.

Installation:
Replace circlip.

2826103 - click to zoom
 
Pull off constant velocity joint complete
with dust cover.

2826104 - click to zoom
 
Press knurled head bolts and washers
out of the constant velocity joint.

2826105 - click to zoom
 
Press off dust cover.

2826106 - click to zoom
 
Pack new constant velocity joint with
60 grams (2.1 oz.) of grease*.

Note:
Don´t cant the inner race with cage to
prevent the balls from falling out.


Siehe auch * Source of Supply: HWB
2826107 - click to zoom
 
Place gasket in the shoulder provided
for this purpose.
Press on dust cover.

Installation:
Check for correct position of bores.

2826108 - click to zoom
 
Press in knurled head bolts with
washers.

2826109 - click to zoom
 
Clean splines to remove grease and
apply a coat of bolt cement*.

Important!
Keep bolt cement out of ball paths.


Siehe auch * Source of Supply: HWB
2826110 - click to zoom
 
Drive constant velocity joint on propeller
shaft with Special Tool 23 1 040.

2826111 - click to zoom
 
Insert circlip.

Note:
Check for correct and tight fit.

2826112 - click to zoom
 
Install hose clamp on dust cover.

2826102 - click to zoom
 
CONSTANT VELOCITY JOINT

1 Transport cap
2 Circlip
3 Constant velocity joint
4 Gasket
5 End cover
6 Dust cover
7 Propeller shaft
8 Fillister head bolt
9 Washer

2826100 - click to zoom