Disconnect oxygen sensor plug on right wheel house. Take electric leads out of holders.
Unscrew both exhaust pipes on the exhaust manifolds.
Installation: Replace self-locking nuts. Check gaskets, replacing if necessary.
Loosen support on transmission. Unscrew support on the exhaust tab.
Installation: Tighten bolts only after finishing installation of the exhaust assembly without tension.
Unscrew holder for exhaust suspension.
Installation: Adjust the holder by moving the tabs on the exhaust and tighten bolts only after finishing installation of the exhaust assembly.
Support the entire exhaust assembly weighing about 50 kg (110 lbs.) with a lifting fixture. Unscrew suspension on left and right sides.
Installation: Align retaining pins to be parallel to the rubber mounts.
Installation: Install tail panel. Align tailpipe in the body opening. Vertically on the rear suspension points. Horizontally by loosening and adjusting the connecting flanges.