BMW Z1
»
12 - Engine Electrical Equipment
»
12 14 000 - Pulse sender - replace / Increment wheel - check
REPLACING PULSE SENDER
Unscrew setscrew.
Installation:
Check pulse sender for tight fit and
damage.
Disconnect plug (m 20).
Note:
Pull out protective rail to side.
1 = Inductive pulse sender
2 = Cylinder identifying sender
Checking increment Wheel (m 20):
1. The TDC mark must be located in
the middle of a tooth gap.
2. A large gap must be located after
one tooth away from the TDC mark.
If not, replace the vibration damper.