REPLACING ONE SPARK
PLUG CONNECTOR

Strip the ignition lead after cutting off
the old spark plug connector.
Hold the connector flush to the pliers
and squeeze it on the lead.
Use Special Tool 12 1 080 (stripping
pliers)*.
Strip ignition lead insulation by 5 mm
(o.197´´).


Siehe auch * Source of Supply: HWB
3212136 - click to zoom
 
Place the ignition lead in Special Tool
12 1 096 and slide it into the spark
plug connector far enough, until the
connector is heard to engage.
Unse lubricating spray (Special Tool
12 1 098) if necessary.

3212137 - click to zoom