Disconnect plug (5) and guide it together with the rubber grommet through the bore.
Disconnect linkage.
Note: A removed convertible top will make adjustments on the linkage easier.
Unscrew screws. Turn the door push button about 90° while removing.
Installation: The sheet metal tabs on the door push button opening must be bent over to prevent losing the ring, with which the door push button is screwed.
- Insert door push button.
Guide wire with rubber grommet through hole. Check for correct fit of rubber grommet in the hole.
- Connect plug (5). - Install rear side panel. - Screw on door push button. - Connect linkage. - Install rear pillar panel.