REMOVING AND INSTALLING LEFT / RIGHT REAR SIDE PANEL Remove tail light assembly - see Group 63. Right Side: Take off tank cap. Install tank cap again after removal of the side panel - danger of fire from escaping gasoline vapors. 63 13 000 | |
Shut trunk lid. Raise top lid. Unscrew screws. | |
Shut top lid. Raise trunk lid. | |
Pull off clip (1) from the wheel house and clips (2) from the tail light opening. | |
Installation: The flat side of clip (2) faces down. 1 Side panel 2 Clip 3 Rubber seal 4 Front or tail panel | |
Unscrew screws - counterhold on nuts. | |
Open door. Push brush aside and unsrew bolt. | |
Installation:@L 1 Bolt 2 Outer body panel 3 Rubber grommet - don´t displace while tightening bolt (1) 4 Chassis | |
Pull out side panel at top over the door lock and then pull back out of the rubber mounts. | |
Installation: Coat rubber mounts with a rubber lubricant. Install side panel by sliding the guides into the rubber mounts. Check for correct seating of seals to the mating parts. | |
Installation: Insert rubber seal (2) for the door lock in side panel (1) and push on retainer (3). |