REPLACING CABLES Disconnect battery ground lead. Remove trim panel at bottom right for dashboard - see 51 45. 51 45 000 | |
Remove radio with connection housing - see Group 65. Lift out rear fog light switch and pull off plug. 65 11 000 | |
Pull off control knobs. | |
Unscrew screws. | |
Unscrew screws. Pull heater face plate forward and pull off plug for blower switch. | |
Lift cables out of control panel. Lift out retainer (1). Disconnect cable (2) in lever (3). | |
Installation: Connect cable (1) in sliding control (2). Press sliding control and air flap against the stop. Turn sleeve (3) enough that it can be placed in the opening. Lock cable with retainer (4). | |
(Footwell Cable) Pull out retainer (1). Disconnect cable (2) in lever (3) and take off. | |
Installation: Cable sleeve (1) must be flush with stop (2). | |
(Window Ventilating Cable) Pull out retainer (1). Disconnect cable (2) in lever (3) and take off. | |
Installation: Cable sleeve (1) must be flush with stop (2). | |
(Fresh Air Flap Cable) Pull out retainer (1). Disconnect cable (2) in lever (3) and take off. | |
Installation: Cable sleeve (1) must be flush with stop (2). | |
(Temperature Mixing Flap Cable) Lift out retainer (1). Disconnect cable (2) in lever (3). | |
Installation: Connect cable. Turn temperature control wheel against stop (cold or warm). Also move the temperature mixing flap against stop (cold or warm) by turning knurled nut (1). Hold cable with retainer (2). | |
Pull out retainer (1). Disconnect cable (2) in lever (3) and remove. |