ALIGNING ENGINE HOOD

Loosen bolts.
Screw in stop pads.

Align engine hood with the side
panels, front panel and headlights.
Tighten bolts of engine hood.

Align height at front end of the engine
hood by adjusting the lock.
Adjust the engine hood in height that
the engine hood is about 1 mm (0.039")
deeper than the side panels.

Note:
View of lock from the right.

After adjusting unscrew the stop pads
far enough that the engine hood is
preloaded slightly and positioned in
one plane with the side panels.

Note:
The left headlight is removed in the
picture for a better view.

Adjusting Rear Guide Roller:

Loosen bolts.

Adjust holder laterally until the guide
roller slides into the catch perfectly.
Check the gap between the side panel
and engine hood on left and right
sides.

Adjusting Rear Engine Hood Height:

Loosen bolts (1 and 2).
Adjust catch on bolt (2) in such a
manner that a closed engine hood is
level with the side panels.

Note:
The deeper the lock, the further forward
the engine hood.